NBMiner v39.0更新日志:
feature : ethash New LHR mode for ETH mining on RTX 30 series LHR GPUs, supports Windows & Linux, able to get ~70% of maximum unlocked hashrate.
This mode can be tuned by argument -lhr , only works for ethash right now.
-lhr default to 0, meaning even if -lhr is not set, LHR mode with -lhr 68 will be applied to LHR GPUs if certain GPUs are detected.
Tune LHR mode by setting -lhr <value> , a specific value will tell miner try to reach value percent of maximum unlocker hashrate, e.g. -lhr 68 will expect to get 68% of hashrate for same model non-LHR GPU.
Higher -lhr value will results in higher hashrate, but has higher possibility to run into lock state, which will leads to much less hashrate.
A good start tuning value is 68, which has been tested to be stable on most rig configurations.
-lhr value can be set for each GPU by using comma separeted list, -lhr 65,68,0,-1 , where -1 means turn off LHR mode.
Known issue
unable to unlock LHR hashrate under windows driver 471.11
===================================================
功能 : ethash 新增部分破解 LHR 版本显卡算力的功能,适用于win和linux,大约可解锁70%左右的满速算力。
该功能通过-lhr 参数启动,目前只对ethash 算法有效
如果检测到有LHR显卡,即使不加-lhr 参数时,也会自动对其使用 -lhr 68 的参数应用。
其他非LHR显卡挖矿不受影响,3060 v1版本需要设置 -lhr <value> 才启用 LHR 模式
可通过 -lhr <value> 来手动指定,<value>的值指尝试让miner达到的算力目标,比如 -lhr 68 即尝试让miner采用满算力(不带锁的卡)的68%的有效算力来运行,即越大算力越高。
-lhr 的数值越大,挖矿过程中被锁算力的概率越大,默认值 68 是开发测试中可以长期稳定运行的值,用户可以尝试调高或者调低该数值,以取得算力和稳定性的平衡
可通过 -lhr 65,68,0,-1 格式来单独指定每一张卡的参数,其中 -1 指关闭 LHR 破解功能
已知问题
windows 471.11驱动,无法解锁LHR算力 NBMiner v39.0官方原版下载连接: 2people reactedNBMiner_39.0_Linux.tgz 软件大小:10.2 MB NBMiner_39.0_Linux.tgz.sha256 软件大小:89 Bytes NBMiner_39.0_Win.zip 软件大小:10.6 MB NBMiner_39.0_Win.zip.sha256 软件大小:87 Bytes
注意:官方原版软件下载连接为国外服务器,部分地区可能无法下载。 |